Mechanical Engineering questions and answers

Mechanical Engineering Questions and Answers

Challenge your knowledge of machinery, prepare for your exams or aptitude tests with these Mechanical Engineering questions and answers.

21.

If the air-fuel mixture ignites before the spark takes place at spark plug, the condition is called

A.

detonation

B.

ignition

C.

pre-ignition

D.

rumble

Correct answer is C

No explanation has been provided for this answer.

22.

If the level of tension in the belt is too high, it can result in a loss of power or in bending of the rotating shaft or crankshaft.

A.

Correct

B.

Incorrect

C.

Cannot say

D.

Tension in the belt can never be too high

Correct answer is A

No explanation has been provided for this answer.

23.

The co-efficient of rolling resistance for a truck weighing 63 500 N is 0.018. The rolling resistance to the truck is

A.

1.143 N

B.

11.43 N

C.

114.3 N

D.

1143 N

Correct answer is D

No explanation has been provided for this answer.

25.

If the air-fuel mixture in a spark ignition engine is too rich, then air-fuel ratio is about

A.

17:1

B.

15:1

C.

13:1

D.

10:1

Correct answer is D

No explanation has been provided for this answer.

26.

The effect of having excess camber is

A.

excessive steering alignment torque

B.

hard steering

C.

too much traction

D.

uneven tyre wear

Correct answer is D

No explanation has been provided for this answer.

27.

In a ventilated disc brake,

A.

a duct directs air towards the caliper for cooling while the vehicle is moving

B.

caliper is covered with cooling fins

C.

disc contains many small holes for optimum cooling performance

D.

disc contains radial vanes between its rubbing surfaces for optimum cooling performance

Correct answer is D

No explanation has been provided for this answer.

28.

The firing order for an in-line four cylinder I.C. engine is

A.

1-2-3-4

B.

1-3-4-2

C.

1-2-4-3

D.

1-3-2-4

Correct answer is B

No explanation has been provided for this answer.

29.

In automobiles, G.V.W. refers to

A.

gross vehicle width

B.

gross vehicle weight

C.

gross vehicle wheel base

D.

gross vehicle wheel track

Correct answer is B

No explanation has been provided for this answer.

30.

Positive camber is used to compensate for wheels tilting inward due to the weight of the vehicle

A.

Yes

B.

No

C.

Cannot say

D.

It depends

Correct answer is A

No explanation has been provided for this answer.


Sub-categories

Automobile Engineering