An electric pressing iron is connected to the mains using an insulated wire. wire becomes very hot.

The heat generated in the wire can be minimized by replacing the wire with one of?

 

Similar Questions

The horizontal floor of a water reservoir appears to be 1.0m deep when viewed vertically from above....

The maximum permissible current through a galvanometer G of internal resistance 10$\Omega$ is 0.05...

A ball of mass 5.0kg hits a smooth vertical wall normally with a speed of 2m-1 and rebounds with the...

A metal sheet of area 100cm$^2$ was heated through 70°C. Calculate its new area if the linear ...

At low humidity in an environment, the human skin is usually? ...

The viscosity of a fluid depends on the following factors except the? ...

The velocity ratio of an inclined plane where angle of inclination in θ is ...

A block and tackle pulley arrangement has 6 pulleys in which an effort of 50N supports a load of 200...

Which of the following is/are in random motion? i. Pollen grains in water ii. The molecules of h...

In which of the following is a stationary wave produced? i. A vibrating turning fork held near th...